![]() Remote Viewing)Įnter the Router's WAN IP address in the HostĮnter your login username and password for the camera and then tap Save To add the camera in the app for remote viewing, close the app, turn off your mobile device's WiFi, make sure your mobile device is connected to the mobile network, open the app again, then tap Add.The camera you just added to the app is for local viewing only, meaning that you can only view this camera when your mobile device is connected to the same network as your camera. Tap Back, repeat Step 7, but do not change the Host Address, and continue adding the camera.Note: After tapping Save at Step 7 above, if the middle of the screen shows a spinning ball icon for more than 10 seconds, this means that your Router most likely does not allow you to view the camera from the local network using the router's WAN IP address. You should now see the video from the camera. Tap on the white box to the right of the camera name to check it and then tap Connect.Tap the Save icon in the top right of the app.Enter your login username and password for the camera.Change the Host address to your Router's WAN IP address.You will input the Router's WAN IP address in the app next. This is typically found on your Router's status page. Locate your Router's WAN (Public) IP address, and write it down. Login to your Router and create one rule with TCP port 80 to the IP address of the camera and create another rule with port 554 also to the IP address of the camera for the following models. ), login to your Router, go to Firewall settings, go to Port Forwarding (Virtual Server) settings, and then create a rule with TCP port 80 to the IP address of your camera for the following models. To create Port Forwarding (Virtual Server) rules, from a network computer (or your mobile device when applicable), open a web browser, open the Router's configuration page (e.g. ![]() Please contact your Router manufacturer for assistance in setting up a DHCP reservation for the camera (Host) and create Port Forwarding (Virtual Server) rules using the camera's IP address and Port number. 192.168.20.120) to the camera every time, and this is normally done using the Router's DHCP reservation feature. You will want the Router to assign the same IP address (e.g.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |